Flash Corruption: Software Bug or Supply Voltage Fault?
Flash memory is commonly used to store firmware in embedded systems. Occasionally, the firmware stored in the Flash memory in some systems is accidentally corrupted, preventing the system from booting up after power-on. Flash corruption is commonly associated with a software bug. However, it is also commonly understood that the probability of Flash corruption increases either during power cycling tests or during margining tests.
This article examines Flash corruption and its causes beyond a software bug, and suggests methods to minimize the corruption.
Download this whitepaper to find out more.
Read More
By submitting this form you agree to Lattice Semiconductor Corporation contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. Lattice Semiconductor Corporation web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
Related Categories: Communication, Comparators, Embedded, Microcontrollers, Power, Processors, Resistors
More resources from Lattice Semiconductor Corporation
2:1 MIPI CSI-2 Bridge Soft IP
In some cases, mobile Application Processors (AP) may not have enough interfaces to support the number of image sensor inputs required for a partic...
POWER CONSIDERATIONS IN FPGA DESIGN
Power has always been a design consideration. Traditionally, though, a lower priority has been assigned to power than to most other variables (spee...
RELIABLE RESET GENERATION FOR TI TMS320C6XXX (“DAVINCI”) PROCESSORS
Every microprocessor or DSP requires a reset generator circuit or IC to perform two functions: (1) start up from a fixed condition after the suppli...
